[2017 PDF free download] Latest Cisco 200-125 Dumps Exam Practice Questions, Best 200-125 Exam PDF Free Download At Lead4pass (Q5-15)

Update the latest Cisco CCNA 200-125 dumps pdf and vce practice files. Download free latest Cisco CCNA 200-125 dumps exam questions and answers at Lead4pass. https://www.lead4pass.com/200-125.html dumps pdf practice files. Lead4pass offers high quality Cisco CCNA 200-125 exam dumps training materials and study guides, pass Cisco 200-125 exam test easily.

Download Latest Cisco 200-125 Dumps PDF From Google Drive: https://drive.google.com/open?id=0B_7qiYkH83VRSnZDMkVUWDJzLWM

Download Latest Cisco 200-310 Dumps PDF From Google Drive: https://drive.google.com/open?id=0B_7qiYkH83VROXBqSzZWaThrVlE

QUESTION 5
Which three statements accurately describe Layer 2 Ethernet switches? (Choose three.)
A. Spanning Tree Protocol allows switches to automatically share VLAN information.
B. Establishing VLANs increases the number of broadcast domains.
C. Switches that are configured with VLANs make forwarding decisions based on both Layer 2 and Layer 3 address information.
D. Microsegmentation decreases the number of collisions on the network.
E. In a properly functioning network with redundant switched paths, each switched segment will contain one root bridge with all its ports in the forwarding state. All other switches in that broadcast domain will have only one root port.
F. If a switch receives a frame for an unknown destination, it uses ARP to resolve the address.
Answer: B,D,E

QUESTION 6
Which two statements about late collisions are true? 200-125 pdf (Choose two.)
A. They may indicate a duplex mismatch.
B. By definition, they occur after the 512th bit of the frame has been transmitted.
C. They indicate received frames that did not pass the FCS match.
D. They are frames that exceed 1518 bytes.
E. They occur when CRC errors and interference occur on the cable.
Correct Answer: AB

QUESTION 7
Which command can you enter to set the default route for all traffic to an interface? 200-125 dumps
A. router(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1
B. router(config)#ip route 0.0.0.0 255.255.255.255 GigabitEthernet0/1
C. router(config-router)#default-information originate
D. router(config-router)#default-information originate always
Correct Answer: A

QUESTION 8
Refer to exhibit:
200-125 dumps
Which two destination addresses will be used by Host A to send data to Host C? (Choose two.)
A. the IP address of Switch 1
B. the MAC address of Switch 1
C. the IP address of Host C
D. the MAC address of Host C
E. the IP address of the router’s E0 interface
F. the MAC address of the router’s E0 interface
Answer: C,F

QUESTION 9
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?
A. This is a 10 Mb/s switch port.
B. This is a 100 Mb/s switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC.
Answer: C

QUESTION 10
In an Ethernet network, under what two scenarios can devices transmit? 200-125 dumps (Choose two.)
A. when they receive a special token
B. when there is a carrier
C. when they detect no other devices are sending
D. when the medium is idle
E. when the server grants access
Answer: C,D

QUESTION 11
A network administrator is verifying the configuration of a newly installed host by establishing an FTP connection to a remote server.
What is the highest layer of the protocol stack that the network administrator is using for this operation?
A. application
B. presentation
C. session
D. transport
E. internet
F. data link
Answer: A

QUESTION 12
Which of the following describes the roles of devices in a WAN? 200-125 pdf (Choose three.)
A. A CSU/DSU terminates a digital local loop.
B. A modem terminates a digital local loop.
C. A CSU/DSU terminates an analog local loop.
D. A modem terminates an analog local loop.
E. A router is commonly considered a DTE device.
F. A router is commonly considered a DCE device.
Answer: A,D,E

QUESTION 13
Which two statements about IPv6 and routing protocols are true? (Choose two.)
A. Link-local addresses are used to form routing adjacencies.
B. OSPFv3 was developed to support IPv6 routing.
C. EIGRP, OSPF, and BGP are the only routing protocols that support IPv6.
D. Loopback addresses are used to form routing adjacencies.
E. EIGRPv3 was developed to support IPv6 routing.
Correct Answer: AB

QUESTION 14
Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has builtin security mechanisms?A. HDLC
B. PPP
C. X.25
D. Frame Relay
Correct Answer: B

QUESTION 15
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. 200-125 dumps
The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?
A. the OSPF route
B. the EIGRP route
C. the RIPv2 route
D. all three routes
E. the OSPF and RIPv2 routes
Correct Answer: B

Read more: https://www.lead4pass.com/200-125.html dumps pdf questions and answers free update.

Watch the video to learn more: 

         

Loading Facebook Comments ...

Leave a Reply

Your email address will not be published. Required fields are marked *